Thank you Mark, it helps in the manner that I’m on the right way. My intension is also to accerlate the switching timing of GPIO’s of a N3.
Unfourtnately I struggle at the intial point to compile the firmware of the device. I just follow the instructions (see link) but it still fails.
Whenever I start the build process it looks good at the beginning, in the meantime (after appr. 2-3 minutes) first build errors occurs. Afterwards the entire build finish with 104 errors.
The first error occurs while building the project “…\Netduino3\TinyCLR\TinyCLR.proj”.
Do you have any idea what might be wrong?
I’m aware that I’m mixing up the inital question with creating firmware of a Netduino device, but it would be great if you could support me at this point.
Christian
